Foundation pile testing instrument

Product consultation
    • PDA-8G 8th generation high strain piling analyzer
    • Model: PDA-8G
      Country of origin: American PDI company Use: PDA-8G can be used to evaluate the pile bearing capacity and its integrity. The field measured data needs to be further analyzed using CAPWAP fitting software, and the analysis results have a good correlation with the static load test.
    • New PIT-QFV Low Strain Pile Integrity Tester
    • Model: PIT-QFV
      Country of Origin: American PDI Company Use: PIT-QFV pile body integrity tester is a sharp tool for quickly and easily evaluating the integrity of bored piles and driven piles. This product is used to test the integrity of various piles and driven piles to determine the degree and location of pile defects. It is the smallest and lightest pile integrity tester in imported equipment, following PIT-X and PIT-VV. Later, the latest version launched by PDI in 2016.
    • CHAMP-Q Acoustic Transmission Tester
    • Model: CHAMP-Q
      Origin: United States PDI
      Uses: The tester uses the cross-hole acoustic transmission method (CSL) to evaluate the concrete quality and consistency of bored piles, underground diaphragm walls, spiral piles and other basic structures.
    • TIP Thermal Anomaly Pile Integrity Tester
    • Model: TIP
      Origin: American PDI Company Application: Thermal anomaly pile integrity tester is used to evaluate the quality of concrete pouring pile body. TIP thermal anomaly pile integrity tester uses the heat generated by cement solidification (hydration energy) to evaluate concrete pouring. The pile body quality can be applied to bored piles, spiral piles, etc.
    • SHAPE hole forming quality detector
    • Model: SHAPE
      Country of Origin: American PDI Company Use: Hole-forming quality tester can measure bored pile hole diameter and pile hole volume, control verticality quality, 4 or 8 channel simultaneous 360 ° scan, fast and economical test
    • SQUID hole bottom sediment thickness detector
    • Model: SQUID
      Country of Origin: American PDI Company Use: After drilling is completed and before concrete is poured, the pile hole is tested, and the bearing capacity of the soil layer at the end of the pile can be detected.
  • 1
  • 2
  • 3
  • Applications
    Case Study | PRIMAX 2500 Heavy Hammer

    In pavement design and bearing capacity evaluation, the drop hammer deflector (referred to as FWD) is one of the most advanced pavement strength non-destructive testing equipment in the world. Its measurement results are accurate and the amount of information is large. Compared with traditional Beckman beam measurement deflection,

    Apageo Mena side pressure meter in a university should

    Laboratory test of Apageo Mena side pressure meter in a university. The side pressure test can be traced back to Germany in the 1930s. This is also the prototype of the earliest single-cavity side pressure tester. After several generations of efforts, until 1957, the French engineer Louis Meiner studied

    PAC acoustic emission system for studying rocks

    I. One of the nondestructive testing methods for the concept of acoustic emission system. The phenomenon of localized stress concentration in materials, the rapid release of energy and the generation of transient elastic waves is called acoustic emission (AEoustic Emission, AE for short), and is sometimes called stress wave emission. Material under stress

    A1040 MIRA array ultrasonic tomography

    The MIRA ultrasonic tomography scanner uses a combined detection synthetic aperture focusing technology to achieve focus on each point in the half space. The data set consists of the information collected by all measurement pairs of the instrument antenna. As a result, a cross-sectional view of the test body is generated, with different

    Proceq GPR concrete radar for steel

    The first ultra-wideband GPR Live reinforced concrete radar uses unique continuous wave step frequency technology to achieve the widest spectrum in the market. All applications that typically use the 0.2 to 4.0 Ghz range can now be covered with a single device. No need to buy and switch

    Mira application for model test block

    Application examples of Mira for model test block Figure 1 Marking test points Figure 2 Scanning test object The test block has a length, width, height, and size of 1000mm * 600mm * 600mm, and the concrete pouring strength grade is C20, which is poured in two layers. Occupied sections are placed at the horizontal section of the layered concrete placement

    MIRA ultrasonic imager used in Zhejiang

    I. Project introduction The floodgate of Laohutan Reservoir is in the form of open surface holes, with a total of 3 holes. The clear width of each hole is 8.0m, the elevation of the weir top is 46.00m, and the weir surface adopts WES curve. ) Open-top curved steel gate. Looking from upstream to downstream, left

    Case Study | DS-50A Dynamic Response

    In order to ensure that under the influence of temperature changes, concrete shrinkage and creep, and load effects, the bridge span structure can be deformed freely according to the static diagram and the vehicle can pass smoothly. It should be between the two adjacent beam ends, the beam Telescopic between end and abutment back wall

    Official WeChat
    official Weibo
    Infrared camera, slope monitoring, inclinometer, strain gauge, pressure aging instrument High-tech test instrument comprehensive solution provider
    • 400-700-9998
    • Service hours: Monday to Sunday 9: 00-18: 00
    • E-MAIL: marketing@epc.com.hk
    大陆总部地址:广州市天河区体育东路116号财富广场西塔2301 香港公司地址:香港葵涌梨木道79号亚洲贸易中心12楼 热搜关键词:静态数据采集仪,手持式应变记录仪,多通道动态数据记录仪,汽车六分量测试系统,高速扩展扫描箱,超小型动态测试仪,海上风电 地震预警,地震监测,透火焰热像仪,无电缆静力触探,路面材料试验机,高温高压岩石三轴仪,长基距变形传感器,分布式光纤应变监测,静力水准仪 Copyright © 2008 ~ 2018 Earth Products China Ltd. all rights reserved. Guangdong ICP No. 12064742 Continental headquarters address: 2301, Fortune Plaza West Tower, 116 Tiyu East Road, Tianhe District, Guangzhou, Hong Kong Company Address: 79 Lei Muk Road, Kwai Chung, Hong Kong Hot search keywords on the 12th floor of Asia Trade Center : static data acquisition instrument, handheld strain recorder, multi-channel dynamic data recorder, automotive six-component test system, high-speed expansion scanning box, ultra-small dynamic tester, offshore wind power earthquake warning , Seismic monitoring, Flame-through thermal imager, Cableless static sounding, Pavement material testing machine, High temperature and high pressure rock triaxial instrument, Long base distance deformation sensor, Distributed optical fiber strain monitoring, Static level
    the products world
    about us
    必赢真人娱乐 真人游戏平台注册 七乐彩 星力捕鱼